I wouldn't change speedo gears till after the rear change as going from the factory 4.11 to 3.55 rear gear will put your reading much closer to...
Our rule of thumb is over 15" of vacuum go with the vacuum booster (easier to plum in--one vacuum line) and under 15" use the hydroboost. The...
It's gone, thanks for looking.
I hesitate to tell about any parts since there was no interest in a freshly rebuilt 54 235 with the dual range Hydramatic for $450 with no...
These are from a 52 in the shop but don't know if it still has the original hood. For American made trucks the "What year is it?" page at the...
I like your thinking. I'm sure someone on the site can furnish a photo to your liking. If nothing else carry your camera to a show or swap meet...
Change of plans, the 52 owner got a deal (free) on a prettied up 350 so now it looks like the engine is going to find a home in a 59 short step....
If it's oil then most likely an axle seal. I'm sure you have a shop manual that shows axle removal. You have to pull the rear cover, the spider...
On really rare parts we usually scout Hemmings or the car clubs to see if someone will let us borrow, with any deposit they ask for, the needed...
We used to buy piston blanks from Jahns but I believe they have been bought out. They had a cheap cast and a moderately priced forged piston line....
Yep, Bill, V8/auto/ac/pb/ps.Used a MustangII ifs before you could buy an after market kit; you had to actually go to a junkyard and cut the front...
Thirty years ago I built a 46 for the local Veterinarian at the time. A young man came by almost daily to watch the progress and said the art...
That is an old time "Bermuda Bell". It should have a plunger rod run up through the floor that you stepped on for the ding-dong sound.
The "T" knob is for throttle. You could have your engine run at any speed by how far you pulled it out. Was usually used in cold weather to hold...
Sandy, The VW restoration shop just two miles from me gave up on a 54 with a hydramatic because they couldn't find a starter. They probably...
Am putting a Fleetside bed on a 58 and it came with no front panel and has been chopped up at the front. Sure could use a picture showing how a...
Electric gauges should be marked IGN and SENDER on the terminals. Put 12v jumper to IGN and ground the SENDER---gauge should peg out full hot (or...
The 3/4T used the torque tube on the front half and an open shaft on the rear. This lets you keep your torque tube trans but you will need a...
Try going to the PPG (Ditzler) site and log onto their color library. Your local paint supply store can call the Color Library direct and get a...
A CZM is a 1975 262.
Separate names with a comma.
