no part #, just the 4 core radiator.
I just ordered a desert cooler from Jim Carter and was done with it.....
You let out the majic geenie....Truck shop sells them for around $50.
latch savers are a little bit of spring steel that clips on over the tumbler on your latch. Sometimes it is just enough to allow the latch to...
Check out the exhaust heater. It is the little weight that sticks out under the intake. It heats up the intake mixture to get a better running...
Sorry, I have never even looked at one that closely.
Great article, thanks.
i HAVE FOUND THAT THE LATCH SAVERS HELP IN A SITUATION LIKE THIS. aDJUST THE DOOR SO THAT YOU FIND A HAPPY MEDIUM BETWEEN FIT AND NOT DRAGGING ON...
The 350 shouldn't interfere with the sheetmetal. I had to notch over the fatman upper mopunts, but that was all.
With the mount mounted at the bottom, everything should line up with it. Just re drill the holes. Some of the patch panels aren't quite as...
Good God, don't clip it. There are enough front end mfg.s to avoid that. The new kits are EASY to put together, the time saved is worth the...
Check this area out for rust. look under the dash and see how it looks. Mine had rust holes and bondo that is beginning to crack out. I am...
Now, class...Raise your hands and 1 at a time..... I replaced all of the pieces together. When we cut out the steel kick panels and...
You can't get to the weld surface inside the door surface without taking them off. replace one piece at a time and the others should hold it in...
I run an 8.8 ford from a 90 town car...It fills out the fenders with a stock steel wheel, had disc brakes, and a 3.27 ratio. I am about to swap...
Get it all in the door, then line up everything and tighten her down. Go ahead and do the rubber replacement before you re install it.
Cooke's sells built 700rs vor about $400.....
You have to remove the dors to get to the welds.look at my builds on the 50 and 53 to see how I did them....
The flat end goes to the firewall, the end with the arch goes above the steering column. Sometimes you have to give them some hammer lovin' if...
I used the rubber from Jim Carter. It has a curved surface that goes to the top. It should lay flat. There is some adjustment to the vent...
Separate names with a comma.
