383 rotating assemblies ?

[PH84a64C10]

I was just wondering which route to go. I have a block thats already bored 30 over. Basicly I want a street truck with some balls. I have no intentions on racing, but I want to go as far as possible and still be able to use gas from the gas station as oposed to racing fuel. I'm not the most experienced engine builder, so any advice on whick way to go would be awesome.
thanks for all the help everyone.

 

[Nefarious79]

Any engine can be a street engine, its all about timing. You can have a 1000hp twin turbo engine in your car or truck and as long as the timing is on the conservative side you can run 87 octane in it during the week and then put some 93-100 octane in for the weekend and advance the timing and have some fun.

 

[drabo]

A 383 is a torque monster and is alot of fun. If you go this route you will need to have your block machined to clear the new crank. I think it is also externally balanced so it might need a new balancer and flexplate/flywheel.

 

[rsibley]

A 383 is a torque monster and is alot of fun. If you go this route you will need to have your block machined to clear the new crank. I think it is also externally balanced so it might need a new balancer and flexplate/flywheel.

You can buy an internally balanced kit from Summit.Depending on the cam you want to run,you may need to clearance some of your rod bolts.

 

[rollin40]

sbc

I was just wondering which route to go. I have a block thats already bored 30 over. Basicly I want a street truck with some balls. I have no intentions on racing, but I want to go as far as possible and still be able to use gas from the gas station as oposed to racing fuel. I'm not the most experienced engine builder, so any advice on whick way to go would be awesome.
thanks for all the help everyone.

or use a 327 crank and rods.