JCina66
Member
Hi All,
I've just joined the forum and would like to know if anyone has run
into a similar problem. I have a 66-C10 with a factory original tach. The tach does not work because it only has 1 wire attached which is directly in the center of the tach when looking at the back. There are 2 studs which I assume are the terminals for the positive and negative wires and my questions are, where do I terminate these wires on the other end and which terminal stud is the positive on the tach?
One final question, where can I find a service manual or a factory assembly manual for this model truck? (66 C10)
Thanks to anyone that can provide free advise.
JCina66
I've just joined the forum and would like to know if anyone has run
into a similar problem. I have a 66-C10 with a factory original tach. The tach does not work because it only has 1 wire attached which is directly in the center of the tach when looking at the back. There are 2 studs which I assume are the terminals for the positive and negative wires and my questions are, where do I terminate these wires on the other end and which terminal stud is the positive on the tach?
One final question, where can I find a service manual or a factory assembly manual for this model truck? (66 C10)
Thanks to anyone that can provide free advise.
JCina66