Install for 52-up.....
Trique latches for the truck came today. I had both installed in 2 1/2 hours, not including painting.
Start by removing all stock latches and strikers, inside and outside handles. Cut out templates and transfer to door..
Cut the holes, I used a grinder with a cut off wheel and a jigsaw for the smaller parts. Drill the holes in the door faces, marked with the doorplates..
Cut the nub from the window track through the hole...
Bolt on plate....
Install latch and door handle, test a few times.....I found that I needed to bend the arm to the handle out a slight bit to make contact a little better..
Grind off the rivet for the inside actuator...
Trim the new linkage after the second notch, shown beside untrimmed piece..
Connect linkage to latch through this hole...
And to the door handle here...
