Wife's washing machine stopped the spin dry cycle so I did a search and it said either the shaft rag joint or the clutch was bad. Watched a repair video and then jumped into the ring. Where the instructions said to remove washer cabinet (a real bummer) to access the water pump and motor I immediately saw the instructions were for people that don't own a plasma cutter. The water pump is TIGHT against the rear of the cabinet but 30 seconds with the plasma and all is completely accessible. I wonder if I should send an instruction amendment to Whirpool?
-
We have upgraded our forum software! See here for details.
Incomplete instructions
- Thread starter coilover
- Start date
52wasp
Member
nicely done
Evan,
Having spent a LOT of quality time of late with the plasma cutter... I can say I laughed out loud at your solution to the problem at hand. I hope you don't take offense if I refer to it as "Yankee ingenuity".
Evan,
Having spent a LOT of quality time of late with the plasma cutter... I can say I laughed out loud at your solution to the problem at hand. I hope you don't take offense if I refer to it as "Yankee ingenuity".
Zig
Member
Great solution! Pop rivet a piano hinge across the top for easy access next time. 
Bill Hanlon
Member
Enough fun Evan. Did you get it working again?
50 Chevy LS3
Member
It's probably down for louvers and custom paint. If it was the dryer, I'd say paint some flames on it.