Stock Blinker Assembly

Discussion in '1955-1959' started by Deve, Dec 12, 2018.

  1. Deve

    Deve Member

    Joined:
    Jun 2, 2016
    Messages:
    107
    Location:
    Hesston, Kansas
    Hi guys! Need some help. I have a 1950 Chevy 1/2 ton but put the steering column from a 1955 1st series truck in it so I could use the dealer installed stock blinker system.

    The problem is, I can't seem to figure out how it goes together. There are two holes for screws at about 10 and 2 (o'clock) and a stub on the very top of the column. This does not seem right because the little bezel that covers the wires are in the wrong place that way. Can someone shoot a few pictures around the top of the column so I can see what is going on? I can't imagine someone turning the column, so it MUST be just me.
     
  2. Deve

    Deve Member

    Joined:
    Jun 2, 2016
    Messages:
    107
    Location:
    Hesston, Kansas
    I got it figured out. It's been about 10 years since I took the column off a yard truck and its now coming together! I am documenting this so others can see it soon.
     

Share This Page