tail light wiring harness

[LDO]

Ok, working on a 66 C10 and I have pn 52-662 hooked up to the lights. What harness do I need to from from the ends of this harness up to the front of the vehicle?

I've looked at 52-623 but the connectors are round on this an 52-662 has square connectors....

So which one do I need?

 

[vwnate1]

Tailight Harness

O.K. , I assume # 52-662 is the sub harness to the taillights at the back of the truck ? . (pix or link to pix helps a lot here)

It's been a few years since I worked on a '66 but , IIRC the harness you're looking for is part of the main cab wiring loom / harness from the firewall ~

Perhaps a copy of the harness and plug you have , will help folks decipher what you need .

GM didn't change the connectors much over the years and I'm always cruising the yards looking for '69 C/10 parts so maybe a good used harness and plug can be located for you to splice into your existing loom ? .

Others here have up graded to fancy-schmancy Hot Rod harness' and may sell you their old one affordably .

I hope this is helpful , let's try to help a newbie 0out here ! .

 

[LDO]

Nate,
sorry about the lack of pictures. Lets see if this works.

here's what I have connected to the light sockets PN 52-662:

you can see the square plugs that go to another harness as you move forward towards the fire wall.

Here is what I believe to be the next part of the harness which according to the website, goes from the firewall to the rear of the truck PN 52-623:

It looks to me like this is a round connector where the tail light harness is a square connector. Is there something that 'marries' these two together? Thanks for the help!

 

[Rich 5150 69]

Bob the round plug appearance outside is actually square on the inside, I`m looking at mine right now.

 

[Rich 5150 69]

Here`s a pic..

 

[vwnate1]

Hooray !

I knew these good folks would help you out ! .

Why the Vendor didn't take decent photos , escapes me , they don't have any hands on people in the artworks department I guess .

 

[LDO]

You are right on that one Nate. Rich has been a huge help on several of my threads and so have you.
thanks again gents!

Rich, by the way, did you ever get your hazards working correctly?