Recent content by Twisters 4x4

thanks for the help

old post for sure but. I put a NP205 in mine last summer (2014) and after a lot of research I found that GM did use tranny fluid in the transfer case on the later trucks for the less resistance and better fuel mileage. sure glad I did or I would have totally screwed my NEW transmission. there...

Correct hitch for 72 so if the link is still correct, are you saying the 2013 Chevrolet Express 2500 hitch will work on a 1972 Chevy truck? Thanks, Mike T

Vent Shade Clips Well,,,, Larry Green Restorations of Cameron TX was able to instruct me that the window seal peels out. Then (With just a little effort) the clips pop in to hold the vent shades in place. After that, Just slip the seal back in over the clips. About three minutes per side.

Well Mitch, what did you come up with?

I put them where I thought they may go. They are very tight. Is that correct? Anyone going to reply to this thread or is it dead?

well I slide them up where they belong and they are pretty snug. Problem is where do those clips go? There is a very slight bend to them. Wondering if that has something too do with the clips. The ones on my 65 have two 1/16 screws.

Where does it go? I have new Ball Housings and Diverter balls for my A/C dash vents. They came with new felt. Someone have an idea where they should go?

Anyone installed the vent shades from classic Parts? what are the metal clips for and where do they go? I am out of town right now so it might be obvious once i'm home and can see.

And that would be why the long time rule of thumb has been "You can do the bottom without doing the top but not the top without doing the bottom." If it's worn much it will start knocking the bottom out of it.

Thanks, that's what I needed.

I'm looking at a truck that has a issue with the glove box sticker not matching what the truck looks like. Where can I find all the vin numbers on a 72 C10?

good enough for me. Thanks Rich

Greetings, I am about to glue on my door seals and noticed that it seems the original ones were glued on the inside edge as well as the outside. Does anyone have some input on this? Do I need to glue the inside edge? Thanks

Union Pacific 844 Hey Guys, I'm an Engineer for the Union Pacific RR out of Longview TX. Last April I was fortunate enough to Run/Pilot the UP844 on UP's 150th Birthday Tour. (Corsicana - Hearne TX.) As you can imagine it was a great experience. There were people taking pictures on every...