Trying to mock-up my front sheetmetal???

[BIG CHEVY 3600]

I knew there would be some fabricating to be done when I started replacing fenders but with all my pictures I'm still stumped.
You guys with a SBC 350, how did you fit your inner fenders to fit around all that new stuff you have?
Remember a picture is worth a thousand words.
Thanks

 

[ol' chebby]

The 350 shouldn't interfere with the sheetmetal. I had to notch over the fatman upper mopunts, but that was all.

 

[1inxs]

You shouldn't have any problem with the sheet metal. The original gearbox would be the only problem I know of and if you've done a steering conversion, then all should hook up just fine. You can look at my project journal. There are a lot of pictures.
http://www.hotrodders.com/forum/journal.php?action=view&journalid=25573&page=11&perpage=5&reverse=

 

[BIG CHEVY 3600]

1inxs
You have the original front axle, mine is a MII and probably I'll need to notch for the uppers.

 

[Kens 50 PU]

Put the radiator support on the frame and try a test fit. Odds are you'll need to trim a little bit of the inner panel to clear the upper A's but it should be minimal. When I helped Boop's Dad hang his fenders and hood last year, we had to nibble away on the panels. Boop's truck has a camaro clip and V8.

Good luck.