• We have upgraded our forum software! See here for details.

Factory 4sp question

C

coilover

Member
Joined
Mar 30, 2005
Messages
2,564
Reaction score
136
Location
Plano US
On a factory 4 speed trans in a 50 3600 what holds in the speedometer driven gear? It's caked with grease and I can't see if there is a clamp or if it is necessary to remove the housing on the rear of the transmission. It's sunk into the ground but if it's not necessary to remove the housing I can work through the top and not have to drive my s-l-o-w forklift two miles round trip. In 60 years I have driven many with the granny low but never worked on one---guess they score high in reliability. Thank you;
 
The drive gear is machined in the rear yolk. The gear that the speedo is hooked to has a small bolt and a tab that hold it in. The housing and the gear come out together. Chris
 
Thanks, Chris. I should be able to take it off (the driven gear) from above with the trans floor cover removed. Now do you know anything about chiggers? It's infested where the truck is and I think they are all deviants because they pass across a lot of perfectly good skin to get to a very private and tender area. I can put on long pants and tie a diesel soaked rag tight around the bottom. My wife insists I strip before coming in the house but I get plenty of elbow room at the cafe so it's not all bad.
 
Not the dreaded chigger! Get some "Deep Woods Off" and spray yourself good. Then, after it's too late to figure out that it does not work as good as "they" say, get clear fingernail polish and dob it on any part of the body that itches, and in 3 or 4 miserable days they will be dead! And yeah, for some reason, they ALWAYS go straight for the most private of parts on a body!
 
Women

coilover said:
My wife insists I strip before coming in the house but I get plenty of elbow room at the cafe so it's not all bad.
Click to expand...

Evan~ this sounds like one of those sneaky ways women try to convey a message without actually saying it.

SHE WANTS YOU!!!! :D ;) :p :eek: :rolleyes: :cool:
 
Actually.......

If it's a Muncie 420 tranny , the driven gear screws into the tranny's case and it's sort of recessed so you'll need a socket with fairly thin walls to get ot loose .

Chiggers ~ ugh ! I'm glad I live where they don't now . they like the dsamp parts where you sweat is the deal , they're not freaks like that 16 year old you dated in High School .
 
No Worries !

For some real entertainment , go read some of my goofy posts made before my coffee or when I'm too tired or maybe I simply don't know anything about old trucks .
 
Last edited:
Yep, Neal, that's why I'm finding out what holds the bugger in. I'm under 50 percent on getting private message replies to actually reach the person I'm trying to reach. Always get "an error was comitted" box and being so dumb on computers I have no idea what the error is.
 
Neil, look this over and see if it's what you have in mind. Has finally cooled down to an artic like 102F (39C) so I bundled up and went down to the storage lot to pull it.
 

Attachments

  • speedo drive 001.jpg
    speedo drive 001.jpg
    76 KB · Views: 339
Speedo Driven gear

That's it ! .

Be aware there's many different ones so your speedo might not be 100 % accurate .

Also , don't forget the crush washer under it as it might otherwise leak .
 
You must log in or register to reply here.
Back
Top